DeployStudio ForumThe best location to share your DeployStudio experiences... |
You are not logged in.
Hi all,
Most of my users here are using Macbook Air (and ipad).
I am running an Xserver with 10.6.4 with deploystudio rc19.
Restoring a macbook and a macbook pro using a single image works like a charm.
When I try to restore the image on a new macbook air it does not work.
If I take the image of the macbook air to try to install on macbook pro, it fails too
network is ok as I get the repository browsing and macbook imaging.
Is it the SSD the issue or is there other trick ? I am lost at this point
regards
fred
Offline
More info is probably required to get a good answer... how doesn't it work, what errors do you get. Does it just crash with a kernel error after the image is applied or does the image fail to apply even?
Offline
sorry I have not been specific enough.
I can netboot the macbook air, and get a master from it. I do that using the USB ethernet as I don't have available wifi.
BUT when I try to restore the same master on the macbook or on a pro, I go XDBG message about bad size ( I don't have the logs anymore and no more Air to test )
After reboot, system is no more operational
Is the Air need a special process to deploy it ? Special Netboot, Special image ? does it work only with USB disk boot ?
Does any of you get some success ? I see only old post not really encouraging ...
Offline