You are not logged in.

Announcement

[2017.09.08] DeployStudio build v1.7.8 (checksum, release note).
[2016.08.26] DeployStudio build v1.6.19 (release note).
[2013.02.23] DeployStudio last universal build v1.5.17 (release note).

#1 2017-11-09 22:10:47

Tsnes
Member
Registered: 2017-11-09

trimforce enable as part of the Workflow?

Hi all,

Has anyone successfully got sudo trimforce enable to work as part of the script? I added it at the end of the workflows and it just does a reboot looping.

What did you do to enable this with Deploy Studio's workflow? Another method? If so, please share. :)

Thanks!

Offline

#2 2017-11-10 08:35:00

mjsanders
Member
From: Schiedam, Netherlands
Registered: 2008-09-02
Website

Re: trimforce enable as part of the Workflow?

Never done that, but it should be relatively straightforward.

Can you share the script?
What is the /var/log/ds_finalize.log on the deployed Mac?

It is normal that DS finalize retry 3 times to run the post-install tasks.

Maurits

Offline

#3 2017-11-13 09:39:10

Tsnes
Member
Registered: 2017-11-09

Re: trimforce enable as part of the Workflow?

Actually the reboot went on to more than 10+ times and that's how I knew it didn't work :)

The script is very basic...

yes Y | sudo trimforce enable

When tested locally, it worked. But with the script, it didn't run at all.

I also tried placing it before the reboot, and while the script do get run, it was not enabled at all.

So something else is preventing it from being run, or it is not supported during deployment?

I see someone posted about it as well, under the Future for deploy studio support...

http://www.deploystudio.com/Forums/viewtopic.php?id=7887

Offline

#4 2017-11-13 18:04:16

Trikster
Member
Registered: 2015-06-25

Re: trimforce enable as part of the Workflow?

I was never able to get it to run.  What I ended up doing was creating a task in Apple Remote Desktop and sent it out as root.

Offline

Board footer

Powered by FluxBB