You are not logged in.

Announcement

[2017.09.08] DeployStudio build v1.7.8 (checksum, release note).
[2016.08.26] DeployStudio build v1.6.19 (release note).
[2013.02.23] DeployStudio last universal build v1.5.17 (release note).

#1 2015-09-02 21:15:46

Kmcdermott
Member
Registered: 2015-06-25

Bind to Active Directory Task

I have a work flow that binds to active directory as the last task.  However, the "force local home directories" was not checked.  Is it possible to just run this task without installing the operating system?  I would like to avoid re-imaging 200+ machines!

Sorry if this question seems foolish but I am new to deploy studio.

Thanks in advance for your assistance.

K

Offline

#2 2015-11-02 18:49:10

Meat
Member
From: SF CA US
Registered: 2009-02-04

Re: Bind to Active Directory Task

Hmmmm. Could'a sworn this was answered already. Anyway:
sudo dsconfigad -localhome "enable" -protocol "SMB" -mobile "enable" -mobileconfirm "disable" -useuncpath "disable" -shell "/bin/bash"

Give it a try on one machine that was already bound, then repeat on your remaining previously bound target machines if successful.

You can copy the command to a TextEdit document, place it on a thumb drive, then copy and paste it from the TextEdit document to the terminal window of the target machine.
You'll need to be logged into the target machine as an admin user and enter your admin password after hitting the return key.

Last edited by Meat (2015-11-02 19:09:35)

Offline

Board footer

Powered by FluxBB