You are not logged in.

Announcement

[2017.09.08] DeployStudio build v1.7.8 (checksum, release note).
[2016.08.26] DeployStudio build v1.6.19 (release note).
[2013.02.23] DeployStudio last universal build v1.5.17 (release note).

#1 2015-08-20 23:10:51

ehsmaclab
Member
Registered: 2015-08-20

Computer Group Network Configuration

I created a group for my lab computers. I made it the default so that every new computer gets added to the group. I then setup naming parameters. That works great. However, I tried to have DS configure network settings, too. I thought for each computer booted/imaged that it would incrementally set the IP address. For example, the first computer would be 10.74.55.10, the next 10.74.55.11, etc. However, it isn't working that way.

What is IP Address Scope? What do I put in there if my IP range for the lab is 10.74.55.10-10.74.55.50?

Also, is there a way to append the last 4 digits of the MAC Address to the system?

Offline

Board footer

Powered by FluxBB